Position:Home  > Products  > GPS/GLONASS Internal Antennas  > GPS Internal Passive Antennas
Keywords:

Categories:

Product Name:
GPS/GLONASS Inner Passive Patch
Item no:
VTGPSIP-13
views:
Loading...
Data Sheet PDF Download:   VTGPSIP-13
      


 

GPS Internal Passive Antenna

Part NumberVTGPSIP-13

1.    DimensionUnitmm

2      Electrical Characteristics

2.1 Dielectric Antenna

Form 1

No.

Item

Specifications

Post Environmental Tolerance

1

Center FrequencyMHz

1575.42 MHz

±3 MHz

2

Band WidthMHz

±5 MHz

±1 MHz

3

V.S.W.Rin BW

1.51

4

GainZenith

0 dB

±0.5 dB

5

Polarization

RHCP

6

Impedance

50 Ω

2.2 Mechanical

Form 2

No.

Item

Specification

1

Cable

RG174 75mm

2

Connector

MMCX

3

Mounting

Internal

3      Reliability

ConditionTemperature: 40±5℃

Load: DC=5V±0.5 V

Quantity: 2000pcs

Sustained Time: 480h

4      Environmental Specifications

Post Environmental Tolerance (Refer to the form 1~2 )

ConditionTemperature range 25±3℃

Relative Humidity range 55~75%RH

Operating Temperature range-40℃~+85℃

Storage Temperature range-40℃~+100℃

4.1 Moisture Proof

The device should satisfy the electrical characteristics specified in form 1~2 after exposed to the temperature 40±2℃and the relative humidity 90~95% RH for 96 hours and 1~2 hours recovery time under normal condition.

4.2 Vibration Resist

The device should satisfy the electrical characteristics specified in form 1~2 after applied to the vibration of 10 to 55Hz with amplitude of1.5mmfor 2 hours each in X , Y and Z directions.

4.3 Drop Shock

The device should satisfy the electrical characteristics specified in form 1~2 after dropping onto the hard wooden board from the height of30cmfor 3 times each facet of the 3 dimensions of the device.

4.4 High Temperature Endurance

The device should satisfy the electrical characteristics specified in form 1~2 after exposed to temperature 80±5℃for 24±2 hours and 1~2 hours recovery time under normal temperature.

4.5 Low Temperature Endurance

The device should also satisfy the electrical characteristics specified in form 1~2 after exposed to the temperature-40℃±5℃for 24±2 hours and to 2 hours recovery time under normal temperature.

4.6 Temperature Cycle Test

The device should also satisfy the electrical characteristics specified in form 1~2 after exposed to the low temperature-25℃and high temperature +85℃for 30±2 min each by 5 cycles and 1 to 2 hours recovery time under normal temperature.

Copyright V.Torch All Rights Reserved